1. Cleanup after Installation:

• Hose with plain water or wash with any normal household detergent and then let dry.
• We highly recommend OOPS as one of the best cleaners.
• Windex is useful for removing stubborn marks.
• Difficult marks can be removed with 'Toothpaste', but it must be the white type not gel.
• For Tar marks, Acetone may be used.
  • However it is a solvent for PVC, and should be used carefully.
  • First soak the Acetone into a cloth, and then wipe softly.
  • Never pour Acetone onto tiles since it will soften the surface.

2. Initial Cleanup/Maintenance:

• Remove all debris, dust and grit by sweeping, dust mopping or vacuuming.
• Scrub the floor with a neutral pH (7–8.5) detergent.
• Apply cleaning solution with a mop.
• Scrub with a rotary scrubber with soft nylon brush or automatic scrubber with soft nylon brushes.
• Pick up remaining solution with a wet-vac or mop.
• Rinse with clean water and allow to dry.

3. Apply commercial floor finish:

Commercial and high traffic floors may have dirt or marks that are difficult
to remove. In such situations it is recommended to apply a commercial floor
finish a protective barrier and also to ease subsequent cleaning

• Apply 3 to 4 coats of high quality, commercial, acrylic floor finish.
• Apply with a clean finish mop or finish applicator.
• Allow 30 minutes dry time between each coat.

---

Daily or Regular Maintenance:

Use OOPS:

• We highly recommend OOPS as one of the best cleaners.

Dry Procedure:

• Remove surface soil, debris, sand and grit by sweeping, dust mopping or vacuuming.
• Spray, clean and buff using a rotary machine (175–1500 rpm) with an appropriate pad and spray buff solution. Wet Procedure:
  • Scrub or mop with neutral pH (7–8.5) detergent. If floor is exposed to grease or oil, use a degreasing detergent.
  • Apply cleaning solution with a mop
  • Scrub with rotary scrubber with soft nylon rushes, or automatic scrubber with soft nylon rushes.
  • Pick up remaining solution with a wet vac or mop.
  • Rinse with clean water, and allow floor to dry.

  Removing Stubborn Marks:

  • Windex is useful for removing many stubborn marks.
  • Very Difficult marks can be removed with 'Toothpaste', but it must be the white type not gel.
  • For Tar marks, Acetone may be used.
    • However it is a solvent for PVC, and should be used carefully.
    • First soak the Acetone into a cloth, and then wipe softly.
    • Never pour Acetone onto tiles since it will soften the surface.

  Floor Surfaces does not warrant or guarantee any commercial maintenance products or their performance.